Operation - QEP 22750Q Instrucciones De Funcionamiento

FIGurE 9
inStaLLinG tHe anGLe GUide
1. The angle guide is designed to fit on top of the
rip guide . Simply place angle guide onto the
top of the rip guide . (see FIGURE 10)
NOTE: The angle guide can be placed on either
the left or right side .
FIGurE 10

OPERATION

IMPORTANT: AlWAYS turn off the saw and
remove the plug from the outlet BEFORE adding
or removing accessories and making adjust-
ments .
SAW COULD RESULT IN ACCIDENTAL STARTING
CAUSING POSSIBLE SERIOUS PERSONAL
INJURY.
BeFOre StartinG tHe SaW
1 . Make sure saw is unplugged .
2. Remove the right cutting table and fill the water
reservoir to the fill line (see FIGURE 11). Do not
fill above this level.
NOTE: AlWAYS keep enough water in the
reservoir when operating the saw . DO NOT let
the saw run dry .
3 . Re-attach and close right cutting table .
FAILURE TO UNPLUG THE
IMPORTANT: ALWAYS completely drain the
water reservoir and clean thoroughly after
each use.
FIGurE 11
tO Start tHe SaW
1 . Remove cord from side compartment and
connect it to a GFCI (Ground Fault Circuit
Interrupter) protected outlet
(See FIGURE 12)
3 .Push On/Off switch to the "On" position .
FIGurE 12
2 . Create "drip loop" in the cord (see FIGURE 13)
FIGurE 13
– 7 –