Metabo HPT WH 36DB Instrucciones De Seguridad Y Manual De Instrucciones página 16

Atornillador de impacto inalambrico
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
8. How to use the LED light
By pressing the light selector switch on the switch
panel, the LED light mode changes as Table 6. It is
indicated by green lamp. (Fig. 14)
To prevent the battery power consumption, turn off the
LED light frequently.
Switch panel
Light
Light
section
indicator
switch
lamp
Always-ON
mode
Panel
display
Always ON
State
(turn off after
2 minutes)
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 2 minutes.
9. Tightening mode selector function (Fig. 15)
CAUTION
● Do not subject the switch panel to shock or
damage.
16
Fig. 14
Table 6
SW
Always-OFF
interlocked
mode
mode
Light only
Always OFF
SW-ON
● Select tightening mode while the trigger switch
is released. Failure to do so could result in
malfunction.
Tightening mode
selector switch
(1) Tightening mode selector switch
By using the Tightening mode selector switch on the side
of the tool body, the tightening torque can be adjusted
according to the type of work.
The Tightening mode switches between 4 diff erent modes
each time the Tightening mode selector switch is pressed.
Normal mode allows screws to be tightened smoothly and
gently.
Under normal circumstances, use Normal mode.
Power mode is suitable for heavy-load work that requires
more force, such as tightening long screws.
Use it when you feel that Normal mode lacks suffi cient
power.
Self-drilling screw mode is used for tightening self-
drilling Teks screws. This mode reduces the chances of
overtightening that could result in severing of the screw
head, breakage of the screw, or slippage.
NOTE
○ The appropriate mode diff ers depending on the screw
and the material being screwed. Drive in a few test
screws and adjust the mode setting accordingly.
○ The tightening mode selector switch can only be set
after the battery has been installed in the driver and
the trigger switch has been pulled once.
Tightening
mode indicator
lamp
Fig. 15

Publicidad

Tabla de contenido
loading

Tabla de contenido