Maintenance And Care; Troubleshooting - Schumacher Electric INSTANT POWER XP2260W Manual Del Usuario

• Clean the clamps and the case each time
you are finished using it.
• Recharge the unit once a month when not
in use.
PROBLEM
The Instant Power won't jump
start my car.
The Instant Power won't
power my 12V device.
The battery in the Instant
Power won't hold a charge.

MAINTENANCE AND CARE

TROUBLESHOOTING

POSSIBLE CAUSE
Jump Start/USB Switch is not
turned ON.
Clips are not making a good
connection to the battery.
The Instant Power's battery is
not charged.
The vehicle's battery is
defective.
The 12V device is not turned
on.
The Instant Power's battery is
not charged.
The 12V device draws more
than 15A or has a short
circuit.
The battery is bad (will not
accept a charge).
8
•
• Store clamps on their support posts, to
ensure they do not come into contact with
any metallic surface.
• Never completely discharge the internal
battery.
Turn ON the Jump Start/USB
Switch.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Rock clamps back and forth
for a better connection.
Check the battery charge
status by pressing the
button on the front of the
Instant Power. See DIGITAL
DISPLAY FUNCTIONS
section of this manual.
Have the battery checked.
Turn on the 12V device.
Check the battery charge
status by pressing the
button on the front of the
Instant Power. See DIGITAL
DISPLAY FUNCTIONS
section of this manual.
Disconnect the 12V device.
The internal breaker will
automatically reset after a
minute or two. Try the 12V
device again. If it happens
again, replace the 12V
device.
Have the battery checked.
•
REASON/SOLUTION