Luxibel LX108 Manual Del Usuario página 6

The menu contains the following items:
Menu item Description
Auto Selects the built-in programme.
Static Selects the static colour.
Dim mode Sets the dim mode.
Back Lite Sets the display time (always on; off after 10, 20, or 30 seconds)
Info Allows testing the fixture – shows version and hours
Address Sets the DMX address
Channel Sets the personality (channel mode)
Master/Slave Sets the fixture to master or slave
7.2 Stand-Alone Mode
In stand-alone mode, the device runs one of the built-in programs.
To set the device to stand-alone mode:
1. Connect nothing to the DMX input of the device.
2. Press <MENU> until <AUTO> is displayed and press <ENTER>.
3. Use <UP> and <DOWN> to select a built-in program.
7.3 Master/Slave Mode
The master/slave mode allows connecting several devices to a single master device. All slave devices will
then work synchronously with the master device.
You need to set one device to master mode and all other devices to slave mode.
1. Connect all devices in series with DMX cables.
2. The first unit in the chain functions as the master device. Set up the unit as described above.
3. On the master device, press <MENU> until <MASTER/SLAVE> is displayed and press <ENTER>.
4. Use <UP> and <DOWN> to select <MASTER> and press <ENTER>.
5. On each slave device, press <MENU> until <MASTER/SLAVE> is displayed and press <ENTER>.
6. Use <UP> and <DOWN> to select <SLAVE> and press <ENTER>.
7.4 DMX Mode
This mode allows you to control the device by any universal DMX controller.
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen" to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.
Example:
To use the 1-channel mode, set the start address of the first unit to 1 (CH1), the second to 2 (CH2),
the third to 3 (CH3), and so on. The highest start address is 512.
And so on.
Use the table below to define the correct address.
Channel mode
Start address
4
Channel
Start address
6
Channel
Start address
10
Channel
V. 04 – 22/05/2013
LX108
Start addresses
First unit Second unit
1 5 (1 + 4)
1-4
1 7 (1 + 6)
1-6
1 11 (1 + 10)
1-10
Third unit
9 (5 + 4)
5-8
13 (7 + 6)
7-12 13-18
21 (11 + 10)
11-20 21-30
6
Highest
start address
509
9-12
507
503
©Velleman nv