Chauvet Professional STRIKE 882 Guía De Referencia Rápida página 3

EN
Replacing the
Fuse
DMX Linking
DMX Connection
Master/Slave
Connection
Mounting
Product
Mounting
Diagram
Control Panel
Description
1.
Disconnect this product from power.
2.
Using a Flat head screwdriver, unscrew the fuse holder cap from the
housing.
3.
Remove blown fuse and replace with a good fuse of the same type
and rating.
4.
Screw the fuse holder cap back in place and reconnect power.
The STRIKE™ 882 will work with a DMX controller using a regular DMX
serial connection. A DMX Primer is available from www.chauvetpro.com.
The STRIKE™ 882 uses a regular DMX data connection for its DMX
personalities: 1 Ch, 5 Ch, 6 Ch, and 10 Ch. See the User Manual to connect
and configure for DMX operation.
The STRIKE™ 882 uses the DMX data connection for its Master/Slave mode.
See the User Manual to connect and configure for master/slave operation.
Overhead Mounting
Button
<MENU> Exits from the current menu or function
Enables the currently displayed menu or sets the
<ENTER>
currently selected value into the selected function
Navigates upwards through the menu list and
<UP>
increases the numeric value when in a function
Navigates downwards through the menu list and
<DOWN>
decreases the numeric value when in a function
Clamp
(Model #CLP-15)
Function
3
STRIKE™ 882 QRG
Floor Mounting