Chauvet Professional EPIX BAR 2.0 Guía De Referencia Rápida página 8

ÉPIX™ Bar 2.0 QRG
Series Attachment Instructions
The ÉPIX™ Bar 2.0 can be attached in an end to end formation to create a strip up to 2
meters long from just one rigging point. Do not connect any more than a total of 2
ÉPIX™ Bar 2.0 in a row when hanging vertically.
1. Loosen the fastening knob and wing nut.
2. Slide the connecting bracket out till it stops and tighten the wing nut.
3. Slide the 2
fastening knob, then attach the safety cable.
1
Fastening Knob
Be sure to install the safety cable last when attaching the products in series.
Page 8 of 40
nd
ÉPIX™ Bar 2.0 into the connecting bracket and tighten the
Wing Nut
3
2
ÉPIX™ Bar 2.0 QRG
EN