Installation Procedure - Chauvet Professional EPIX BAR 2.0 Guía De Referencia Rápida

EN

Installation Procedure

Before installing any product, you should completely read through the guide that was
shipped with the product.
1. Carefully remove all items from the package and install on a secure
foundation.
2. Connect the ÉPIX™ Bar 2.0 to the output of the ÉPIX™ Drive 642 using a
standard Ethernet cable.
Clear/Frost Filter Installation
The ÉPIX™ Bar 2.0 includes a frost filter already installed. Follow the procedure below
to install the clear filter.
1. Locate the end cap of the product that does not have the connecting
hardware.
2. Remove the 4 screws from the end cap of the product.
3. Remove filter.
4. Re-install end cap.
Be sure to install the frost filter with the shiny side facing toward the LEDs.
Page 5 of 40
End Cap
ÉPIX™ Bar 2.0 QRG
ÉPIX™ Bar 2.0 QRG