Water Supply - AGP DM5 Manual De Instrucciones

Tighten the bit to the spindle using two wrenches.
Choosing the correct core bit for the job:
Ensure that the bit you are using is suitable for the material you are drilling. There are two main types of
diamond core bit:
-Wet bits (Always use water with wet bits)
-Dry bits

2) WATER SUPPLY

Water is a basic requirement for diamond core drilling. The water serves as a coolant to avoid the working
surface at the tip of the bit from overheating.
To connect the water supply. Attach the quick-release water coupling to a water hose.
WARNING: Check all connections of the water feed system to ensure there are no leaks. Inspect hoses
and other critical parts which could deteriorate.
WARNING: The maximum water pressure should not exceed 70 psi (4
bar).
Use a water collector with a wet vacuum to collect cooling water if nearby
objects could be damaged by water.
WARNING: Never allow water to enter the motor. A perfectly functioning water collector set up must be
used for any drilling performed at an upward angle.
3) SELECTING SPEEDS (DM5)
There are 2 speed ranges to suit the bit size and work piece hardness.
CAUTION: Never attempt to change gears on a running machine! Only
adjust when the machine is at rest.
Select the desired gear range by pressing the release button and then turning
the gear selector either clockwise or counterclockwise into the desired gear. It
will usually be necessary to turn the spindle by hand a little to get it to shift all
the way.
DM5 WET DRILLING RECOMMENDED GEARS (reinforced concrete)
BitØ
28mm
Gear
Gear 2
Gear 1
45mm 62mm
GB
112mm
7
Open
Closed
Water Feed Valve
Release Button
Gear Selector
132mm >132mm