Checks Prior To Use; Checking The Brakes; Checking The Tyres; Lithium-Ion Battery Pack - B+B Togo Manual De Instrucciones

TOGO
| pushing aid

7.2. Checks prior to use

7.2.1. Checking the brakes

Prior to each use, please check the operational reliability of the brakes.
• Switch on the Togo, start carefully in the lowest level and then
release the control lever. The pushing aid must come to a stop as
usual.
• The motor brake is working correctly if you cannot push the
wheelchair without operating the control lever.
• If it is nevertheless possible, the brake is defective. In such cases,
you must no longer use the pushing aid. Please contact your
specialist retailer at once.

7.2.2. Checking the tyres

Prior to each use, please check the sound condition of the tyres.
Regularly check the profile depth of the tyres once a month. The profile
depth should measure at least 1 mm.
Defective or worn tyres must be replaced by a specialist retailer.

7.3. Lithium-ion battery pack

Only use charger supplied for charging.
Before first use, the battery pack must be fully charged in accordance
with the following instructions.
The battery pack consists of maintenance-free batteries with no need
to check the fluid state and that are protected against total discharge.

7.4. Charging the battery pack

Prior to each use, check the charge status of the batteries by looking
at the battery status display of your control unit. If only the red LEDs
of the battery status display are illuminated, you should no longer
undertake any long trips and connect the charger to the pushing aid at
34
once. To prevent this situation, you can keep a second, charged battery
pack available.
1. Plug the mains plug into the socket. The LED illuminates RED.
2. You can then connect the battery pack and charging begins
automatically. The LED illuminates ORANGE.
3. The charging process is complete when the LED illuminates GREEN.
The battery pack can be charged while it is in the pushing aid (upper
Fig.). Alternatively, the battery pack can be charged at a different
location after removal from the pushing aid (lower Fig, battery pack).
The charger should not remain attached to the fully charged battery
pack for more than 8 hours!
8. Service notes for specialist
retailers
We recommend having your pushing aid inspected by a specialist
retailer once a year.
In the case of faults and defects on your pushing aid, return it to your
specialist retailer immediately for repair.
On request, B+B will provide specialist retailers with required
information, documents and wiring diagrams for repair and service. A
training programme for specialist retailers is available.
In case of queries, please contact the B+B Customer Service at phone
no. +49 700/60000 7070.

9. Disposal

If your pushing aid is not used any more and is to be disposed of,
please contact your specialist retailer.
If you wish to dispose of the pushing aid yourself,
please contact your local disposal companies
regarding the applicable local regulations.
Bischoff & Bischoff GmbH | 09.01.2020 - Revision: 1
TOGO
pushing aid |
17
18
19
20
35