Parts And Components; Before Use; Cleaning And Maintenance - cecotec Cumbia COFFEE 66 HEAT Manual De Instrucciones

ENGLISH

1. PARTS AND COMPONENTS

Fig.1
1. Top cover
2. Filter
3. Funnel
4. Heating plate
5. Power button
6. Jar lid
7. Jar
8. Jar handle

2. BEFORE USE

Take the product out of the box and remove all packaging materials.
Make sure all parts and components are included and in good conditions. If any visible signs of
damage are observed, contact the Technical Support Service immediately.
Place the appliance on a flat, stable surface.
Make sure the device is turned off and plug it to a power supply.
Pour water into the tank up to the Max. mark, dispense water several times without coffee and
empty the remaining water.
Clean all the detachable parts of the machine with lukewarm water.
3. OPERATION
Open the top cover and fill the water tank with water. The water level should not exceed the
Max. level marked inside the tank.
Place the funnel inside the water tank and make sure it is properly assembled.
Then, introduce the filter.
Add coffee powder to the filter and close the cover.
Note: A normal cup of coffee requires 1 ground coffee spoon. Try this quantity and then adjust
it to your taste.
Place the jar on the heating plate.
Plug the power cord into the outlet.
Press the power button for the machine to star operating, the red indicator will light up.
Note:
The machine will brew coffee with all the water in the tank. 40 minutes after it has finished, it
will automatically turn off.
The brewing process can be stopped at any moment by pressing the power button. The light
indicator will turn off at the same time.
34
The amount of coffee obtained will be less than the water poured, as some of the water will
remain absorbed by the coffee grounds.
Warning: Once the machine has been stopped, wait 2 minutes until all water drips have been
dispensed before removing the jar. Remove the jar holding it by the handle. Be careful not to
burn yourself!

4. CLEANING AND MAINTENANCE

Turn the appliance off, unplug it from the power supply and allow it to cool down before
cleaning or repairing it.
Clean all the detachable parts of the machine with lukewarm water and soap after each use.
Use a soft, damp cloth to clean the device's surface.
Do not use abrasive cleaners or scouring pads as they could cause damage to the product's
surface.
On the cover's inside part, water droplets may build up due to condensation during operation.
Dry and clean this area with a soft, dry cloth after every use.
Descaling
Calc build-up frequently occurs in drip coffee makers. This build-up is normal and is caused by
minerals commonly found in drinking water. Periodically, your coffee maker will need cleaning
to remove scale or mineral deposits that may form.
Fill the tank with water (4/5) and descaling product or vinegar (1/5) to the MAX mark.
Place the jar on the heating plate. Make sure it is properly placed by aligning the jar's centre
with the brewing outlet.
Press the power button once, the light indicator will turn on red. After a few seconds, water will
be automatically dispensed.
Once the machine has dispensed about 1 cup of water, turn the machine off.
Allow the solution to take effect for 15 minutes and repeat steps 3-5 again.
Turn the appliance on by pressing the power button and allow the water tank to empty.
Operate the appliance with water at least 3 time to rinse it.
5. TIPS
Keep the coffee maker always clean. In order to obtain high-quality coffee with good flavour,
the coffee maker must be clean.
Recommendation: It is recommended to use bottled water when using the appliance.
Store ground coffee in a cool, dry place. After opening a package of ground coffee, reseal it
tightly and store it in a refrigerator to maintain its freshness.
For a full-bodied flavour coffee, by whole coffee beans and grind them just before use.
Do not reuse ground coffee.
ENGLISH
COFFEE 66 HEAT 35