HARDWARE CONTENTS
AA
BB
PART DESCRIPTION
AA
Wooden Dowel
BB
Short Screw
CC
Locknut
DD
Connecting Rod
EE
Long Screw
FF
Back Panel Screws
GG
Shelf Pin
HH
Door Pull
II
Touch-Up Pen
SAFETY INFORMATION
Please read and understand this entire manual before
attempting to assemble, operate or install the product.
This equipment has been tested and found to comply
with the limits for Class B digital devices, pursuant to
Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. The equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on. The
user is encouraged to try and correct the interference
by one or more of the following measures:
(NOT SHOWN ACTUAL SIZE)
CC
DD
QUANTITY
40
2
28
28
8
38
8
2
1
EE
FF
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and
the receiver
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC
rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference,
and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
3
GG
HH
II