Assembling the Right Refrigerator
Door
Install the right-side door first.
1
Lower the door onto the middle hinge
pin. Make sure that the plastic sleeve is
inserted into the bottom of the door.
(1)
2
Fit the top hinge (4) over the hinge lever
latch (5) and into place.
3
Rotate the lever (3) counterclockwise to
secure the hinge.
4
Hook the tabs on the right side of the
hinge cover (2) under the edge of the top
hinge (4) and position the cover in place.
5
Insert and tighten the cover screw (1).
(2)
(3)
(4)
(5)
Assembling the Left Refrigerator
Door
Install the left refrigerator door after the right
door is installed.
1
Lower the door onto the middle hinge pin.
(2)
(3)
(5)
(6)
(7)
(8)
2
Fit the top hinge (7) over the hinge lever
latch (8) and into place.
3
Rotate the lever (6) clockwise to secure
the hinge.
4
Install the grounding screws (5) and
connect the two wire harnesses (4).
5
Push the water tube (3) located at the top
of the left door into the hole beside the left
hinge on the top of the cabinet until it exits
through the back.
6
Insert the water supply tube (3) into the
connector until you see only one scale
mark. Fully insert the tub cover (15 mm).
7
Hook the tabs on the left side of the hinge
cover (1) under the edge of the top hinge (7)
and position the cover in place.
8
Insert and tighten the cover screw (1).
INSTALLATION
15
(1)
(4)