Maintenance And Service - Garland CHOPPER 607 VE Manual De Instrucciones

English

7. MAINTENANCE AND SERVICE

Do not attempt to perform adjustments on the
machine if it is running. Perform all maintenance of
the machine with it placed on a flat, cleared, and
steady surface.
DO NOT ADJUST THE MAXIMUM
PRESSURE LIMIT SCREW! The maximum
pressure has been set at the factory.
Always perform maintenance
or service with the power cord
unplugged from the machine.
WARNING! Do not modify the machine or cutting
elements (blade). Improper use of these elements can
cause SERIOUS PERSONAL DAMAGE OR DEATH.
Removing the security devices, improper
maintenance, or replacements with non-original spare
parts can result in bodily harm.
Perform regular inspections on the machine in order
to ensure efficient operation of the machine. For a
complete service checkup, we recommend taking the
machine to your service technician.
Use only suitable replacement for this machine in
order to obtain a proper performance of the machine.
This replacement can be found in the official
distributors of the machine. The use of other spare
parts can cause risks, damage to the user, people
around and the machine.
7.1. MAINTENANCE AND CARE AFTER USE
Perform the following maintenance operations
and care when you have finished working with
the machine to ensure the smooth running of this
machine in the future.
7.1.1. GENERAL CHECKPOINTS
Inspect the power cord and extension cord for damage
or signs of aging. If you notice that the cord is not in
good condition carry your machine for service.
Do not use the appliance if the cord is damaged
Check the machine and look for loose parts (screws,
nuts, shells, etc.) and damage. Tighten, repair or
replace the parts you found in poor condition. Make
sure there are no leaks or loss of oil. Do not use the
machine if it is damaged or improperly adjusted.
7.1.2. CLEANING
Before cleaning the unit, disconnect the machine.
Warning! Always clean the machine after use. Not
properly cleaning it can cause damage to the machine
and cause a malfunction. Whenever possible, clean
immediately after work. Warning! The cutting tool is
sharp and can cause damage. Wear protective gloves
when cleaning the machine.
Do not clean the engine with water. The electric
motor may be damaged.
Clean the casings of your machine with a cloth
dampened in water. Never use gasoline, solvents,
detergents, water or any other liquid to clean the
machine.
7.1.3. SHARPENING THE BLADE
After using the bandsaw for some time, if you see
the blade has dulled, sharpen it using a soft and fine-
toothed file.
42/120