Briggs & Stratton ELITE 020215 Instrucciones De Uso página 9

2450 psi
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9.
Start engine according to instructions given in engine
owner's manual. Also see operating instructions tag
located on the pressure washer.
WARNING
Rapid retraction of starter cord (kickback) will
pull hand and arm toward engine faster than
you can let go.
Broken bones, fractures, bruises or sprains could
result.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• If engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun.
NOTE: Always keep the throttle lever in the "Fast"
position when operating the pressure washer.
WARNING
Running engines produce heat.Temperature of
muffler and nearby areas can reach or exceed
150°F (65°C).
Severe burns can occur on contact.
Combustible debris, such as leaves, grass, brush,
etc. can catch fire.
• DO NOT touch hot surfaces.
• Allow equipment to cool before touching.
• The pressure washer must be at least 5 feet from structures
having combustible walls and/or other combustible materials.
• Keep at least 3 feet of clearance on all sides of pressure
washer for adequate cooling, maintenance and servicing.
• In the State of California a spark arrester is required by law
(Section 4442 of the California Public Resources Code). Other
states may have similar laws. Federal laws apply on federal
lands. If you equip the muffler with a spark arrester, it must be
maintained in effective working order.
How to Stop Your Pressure Washer
1.
Let engine idle for two minutes.
2.
Turn engine off according to instructions given in
engine owner's manual.
3.
Squeeze trigger on spray gun to relieve trapped
pressure in hose to avoid injury.
2450 PSI Pressure Washer
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• Squeeze trigger on spray gun to relieve trapped pressure,
every time you stop engine. Engage trigger lock on spray gun.
NOTE: A small amount of water will squirt out when
pressure is released.
4.
Engage trigger lock on spray gun when not in use.
How to Use the Adjustable Nozzle
You should now know how to START and STOP your
pressure washer.The information in this section will tell
you how to adjust the spray pattern and to apply detergent
or other cleaning chemicals.
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
• NEVER adjust spray pattern when spraying.
• NEVER put hands in front of nozzle to adjust spray pattern.
1.
Slide nozzle forward when you wish to adjust spray to
low pressure mode (Figure 10). Slide nozzle backward
to achieve high pressure.
Figure 10 — Adjusting Nozzle for Pressure
Forward = Low Pressure
and Detergent Mode
9
WARNING
The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun retains high pressure when pressure
washer is shut down, which can cause injury.
CAUTION
Backward = High Pressure
Mode

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido