Transformation To Operate With Other Gas Type; Cooktop; Instructions To User - Diamond C4GA7-SP Instrucciones Para La Instalación

3.

TRANSFORMATION TO OPERATE WITH OTHER GAS TYPE

- Remove the grills, the flame-spreader and the burning assembly
- Remove the knobs
- Remove the front panel.
REPLACING THE WORKTOP BURNER NOZZLE
Using a size-12 spanner, replace the burner nozzle (Fig.2 position 2) with one corresponding to the type of gas selected,
following Table II Injectors
REPLACING THE WORKTOP PILOT BURNER NOZZLE
- Remove the two blocking dies (Fig.3 position 4) with a 4mm Allen-key.
- Lift the pilot burner's head (Fig.3 position 5).
- Using a size-5 spanner, replace the nozzle (Fig.3 position 4) of the pilot burner with one corresponding to the type of gas
selected and following Table II Injectors
- Before installing the head (Fig. 3 position 5), adjust the primary air by turning its regulator (Fig. 3 position 6). Ignite the
pilot and check the flame's length and quality, which should not be too weak nor too thin, but approx. 20mm long, almost
detached from the head and without a yellow tip (L.P.G. gas).
REPLACING THE IDLE SCREW; BYPASS
- Replace the minimum thermal capacity screw, bypass (Fig. 2 position 1)) with one corresponding to the gas type chosen,
and complying with Table II Injectors
- The thermal capacity in the minimum position should be approx. 30% of the nominal thermal capacity. When you turn the
fast knob from the maximum position ( ) to the minimum position ( ), the burner should not go off nor return.
IGNITING THE PILOT BURNER (COOKTOP)
4.
To ignite the plaque pilot, press the knob (Fig. 7) turning it to the left to reach the symbol (
tion, press the knob deeply down and ignite the pilot. Keep the knob pressed for approx. 20 seconds; when released, the pilot
flame should stay on. Should it go off, repeat the ignition operation. To ignite the burner, turn the knob to position ( ) for the
maximum, and to position ( ) for the minimum. To shut off the burners completely, bring the knob to position ( 0 ).
NOTE: A reduction grill can be used on the small burner.
RECOMMENDED CONTAINERS
Type of burner
Recommended minimum dia-
meter
Recommended maximum dia-
meter

INSTRUCTIONS TO USER

6 KW 3,5 KW
220 mm 200 mm
380 mm 300 mm
- 17 -
); having reached this posi-
GB