Assembly; Packing List; Unpacking; Attaching Wheels - Ford FPWG30TA-J Manual De Uso

Packing List

• Pressure washer
• Quick start guide
• Operator's manual and product registration card
• Spray gun
• Extension wand with quick-connect fitting
• High pressure hose
• Spray nozzles (5) - 0°, 15°, 25°, 40° and soap nozzle
• Wheels (2)
• Hair pins (2), Axles (2), Hub caps (2)
• Spray gun hook (upper)
• Spray gun hook (lower)
• High pressure hose hook
• Foot (2)
• 4-Cycle engine oil (SAE10W30)
Do not attempt to assemble or operate this pressure washer until you have read and
WARNING!
understood this entire manual. If you have any problems assembling or operating this unit
contact your dealer or a qualified service center.
Do not operate this pressure washer if any of the parts are damaged or missing until the
WARNING!
part is replaced. Using this product with damaged or missing parts can cause damage to
the machine or result in serious injury or death.

Unpacking

1. Remove the high pressure hose from box.
2. After the high pressure hose has been removed, carefully open product by cutting down the sides of the box.
3. Remove the product, parts, and all accessories. Make sure all items listed on the packing list are included and not
damaged.
Attaching Wheel Assembly (See fig 1)
• Parts needed - 2 hair pins, 2 wheels, 2 axles, 2 hub caps and 2 self-tapping screws.
• Slide the wheel axle pin through hole located in the center of the wheel.
• Raise or tilt pressure washer so you can slide the wheel axle pin into the wheel mounting hole located on the side of
the frame.
• Secure the wheel assembly by reinserting a hair pin through hole at the end of the wheel axle and pressing until it locks
into place.
• Install the hub cap to the wheel until "Click" and install the self-tapping screw, until the screw is snug.
• Repeat process on the other side of the pressure washer to install the second wheel.

ASSEMBLY

10