Ford FPWG30TA-J Manual De Uso página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To reduce the risk of injection, injury or possible amputation, never direct water pressure
WARNING!
towards people or pets.
The high pressure stream of water produced can cut through skin and underlying tissue. Never squeeze the trigger or
point the spray gun at other people, animals, plants, or fragile objects such as glass, even if the engine is stopped.
This unit is not a toy. Keep unit away from children and pets.
Do not leave spray gun unattended while unit is running.
Make sure the spray gun, nozzle, and accessories are attached correctly.
Never attempt to repair high pressure hose, always replace.
Never attempt to repair leaks with sealant, always replace O-ring or seal.
Never attempt to connect or disconnect hose from pump or spray gun while system is pressurized.
Always release water pressure from unit every time you stop the engine.
WARNING!
Moving parts can catch on clothing, jewelry, and hair.
Do not wear loose clothing or gloves.
Remove jewelry or anything else that could be caught in moving parts.
Tie back or wear protective head covering to contain long hair.
WARNING!
Never wear sandals, always wear protective footwear.
Operate pressure washer from a level and stable surface.
Do not operate from a ladder, scaffolding, or uneven surface as recoil from spray gun could cause you to fall.
Use both hands to control spray gun to control recoil.
Do not over-extend yourself in attempt to reach a little further.
WARNING!
The fuel and its vapors used to power this unit are highly flammable and could explode resulting in serious injury or
death.
Never overfill fuel tank. If fuel spills, move the unit at least 30 feet away from the spill and wipe up any remaining fuel
on the unit before starting the engine.
Never smoke while operating or fueling this unit.
Never operate or store this unit near an open flame, heat, or any other ignition source.
Keep engine free of grass, leaves, or grease which are flammable.
When adding or draining fuel, unit should be turned off for at least 2 minutes to cool before removing fuel cap. If unit
has been running the fuel cap is under pressure, remove slowly.
To keep fuel from spilling, secure unit so it cannot tip while operating or transporting.
When transporting unit, disconnect the spark plug wire and make sure the fuel tank is empty with the fuel shutoff valve
turned to the off position.
SAFETY RULES
Pressure washer can create puddles and slippery surfaces.
Keep engine away from flammable objects and other hazardous materials.
5

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido