Attaching Foot Assembly; Raising Handle; Attaching Upper And Lower Gun Hooks; Attaching High Pressure Hose Hook - Ford FPWG30TA-J Manual De Uso

Attaching Foot Assembly (See fig 1)
• Parts needed - 2 foot, 2 M8 lock nuts.
• Raise or tilt pressure washer so you can line up foot with the hole located at the side of the frame opposite the wheel.
• Align the rubber foot with the hole in the frame where the foot is to be located. Attach foot by inserting the bolt from the
bottom up and install the acorn nut. Wrench tighten until there is a slight crush on the frame tube. (Do not over tighten)
Raising Handle (See fig 2)
• Raise the handle, then screw the thumb knob nuts on the left and right side until they are snug.
Attaching Upper and Lower Gun Hooks (See fig 3)
• Attach the Upper Gun Hook, install M6 screw & lock nut, wrench tighten until the nut is snug.
• Attach the Lower Gun Hook, install M8 lock nut, wrench tighten until the nut is snug.
Attaching High Pressure Hose Hook (See fig 4)
• Align the hole of the high pressure hose hook to hole on the handle bar.
• Install two M6 bolts, wrench tighten until the bolts are snug.
FIG 1
FIG 3
ASSEMBLY
11
90°
FIG 2
FIG 4