Moving And Storage; Troubleshooting - Coleman 9962 Serie Manual De Uso, Cuidado Y Ensamblaje

Con instruciones de cómo encender la parrilla
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7. Make sure the orifice fittings are inside the venturi tube,
then tighten all self tapping screws. (Fig. 29 and Fig. 30)
Burner
Orifice Fitting in Venturi Tube
REPRESENTATIVE ILLUSTRATION
To Clean
• Turn off regulator. (Fig. 23 a)
• Make sure grill is cool.
• Move grill away from flame (including pilot lights) and
other ignition sources.
• Remove propane cylinder from regulator and replace
protective cap on cylinder. (Fig. 23 b)
• Wipe clean with soft cloth and mild dish detergent. Do not
use abrasives. (Fig. 31)
• Grill grate and grease pan are dishwasher safe.
Orifice Fitting
Venturi Tube
Fig. 29
Fig. 30
Fig. 31

Moving and Storage

A collision with the grill, as with any metal object, could
cause injury. Use care when moving a portable gas grill.
Moving the grill:
• DO NOT move the grill or remove cylinder while it is lit or
hot, or with objects on the cooking surface or side table.
• Clean the grease cup before moving the grill to
prevent spills.
• Collapse the grill before moving.
• Move the grill slowly. DO NOT run with the grill behind
you; it could hit you from behind causing injury.
After moving the grill:
• Check all gas connections for leaks that could occur from
the movement.
• Check the venturi tubes to be sure they are still over
the orifices .
Steps to follow before storing grill:
• Clean the grill, including the grease cup.
• Coat the burner lightly with cooking oil to retard rusting.
• For outdoor use only. If the grill is stored indoors, detach
the cylinder outdoors. If left outdoors, remove the cylinder
and cover the grill for protection from the weather. Grill
covers may be purchased from a grill dealer
or manufacturer.

Troubleshooting

Problem: Grill will not light when the igniter
button is pushed or has incomplete burner
flame.
Possible Causes and Solutions:
1. Lack of fuel. Check to see that the cylinder has fuel.
2. Make sure the burner is turned on. Allow up to four
seconds for gas flow to ignite.
3. If burner lights with match but not igniter, check
the ceramic electrode position near the burner, the
condition of the igniter wire and its connections.
Perform igniter test and replace any damaged parts.
4. Check for spider webs or insect nest in venturi and
clean venturi.
5. Check for misalignment of venturi on orifices. Position
venturi over orifices.
6. Burner ports, orifices or knob have blockage. Clean the
components.
7. Regulator failure; grill needs to be replaced.
8. Make sure the regulator and cylinder are properly
assembled. See the section titled "Installing 1 lb.
Propane Cylinders".
English - 12
CAUTION

Publicidad

Tabla de contenido
loading

Tabla de contenido