Installing 1 Lb. Propane Cylinder - Coleman 9962 Serie Manual De Uso, Cuidado Y Ensamblaje

Con instruciones de cómo encender la parrilla
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

■ Once handle is locked
in position, the grill
can easily be moved
to any location in your
campsite or backyard
by grasping the towing
handle. (Fig. 10)
Set up the Grill
■ Rotate counterclockwise the leg locker to release. (Fig. 11)
■ Open up the grill from the folded position. Place one foot
on the towing handle, grasp the handle on side table,
and lift up towards you. Continue to pull up until the grill
stand is fully extended. (Fig. 12)
■ Slide leg extensions
into locking brackets
as shown (Fig. 13).
Install the Grease Cup
■ Pull apart the grease cup holder and insert it into drip
hole on bottom center of grill base. (Fig. 14)
■ Squeeze the grease cup holder toward center and attach
the grease cup. (Fig. 15)
Pull
Pull
Bracket
Leg Extension
Fig. 14

Installing 1 lb. Propane Cylinder

NOTE: Your 9962 Series grill is set up from the factory to
use a 1 lb. disposable propane cylinder.
Only cylinders marked "Propane" must be used.
Fig. 10
This procedure MUST be performed OUTDOORS only!
Read and follow the directions on the cylinder.
• NEVER store a spare L.P. gas supply cylinder under the
grill body or inside the grill enclosure or in the vicinity of
any heat producing appliance.
Failure to follow this information exactly could result in an
explosion and/or fire causing death or serious injury.
Fig. 11
■ Before attaching propane
cylinder make sure
regulator valve is closed.
(Fig. 16)
Tighten by hand only. DO NOT use tools.
Fig. 12
■ Remove plastic cap from
top of propane cylinder
and screw cylinder into
regulator hand tight.
(Fig. 17)
Fig. 13
Fig. 15
English - 6
WARNING
WARNING
DANGER
CAUTION
Fig. 16
Fig. 17

Publicidad

Tabla de contenido
loading

Tabla de contenido