Operations
05 Spin
06 Soil
07 Pre Soak
08 Fabric Softener
09 Super Speed
10 Delay End
36
English
Untitled-3 36
Press to change the spinning speed for the current cycle.
• High (Level 5): Extends the spinning process to effectively
remove moisture from the load. This level uses a stronger
spinning process to remove moisture, so it is not suitable for
wrinkle-free or non-iron fabrics, or overloads.
• (Level 4): Underwear, t-shirts, jeans, and sturdy cottons.
• (Level 3): Jeans, wrinkle-free or wash-and wear items, and
synthetics.
• (Level 2): Delicate items that require a lower spinning speed.
• No Spin (Level 1): The drum does not spin after the final drain
process.
Rinse hold (All indicators are off): The final rinse process is
suspended so that the laundry remains in the water. To unload the
laundry, run a drain or spin cycle.
Spin Only: To run the Spin Only cycle, press Spin for 3 seconds.
When the cycle time and spinning speed appear, press Spin
repeatedly until a desired spinning speed is selected. Then, press
and hold Start/Pause (Hold to Start) to start the cycle. The spinning
time depends on the selected cycle.
Press to change the soil level for the current cycle.
• Heavy (Level 5): For extremely soiled loads.
• (Level 4): For heavily soiled loads.
• (Level 3): For moderately soiled loads. This setting is best for
most loads.
• (Level 2): For lightly soiled loads.
• Light (Level 1): For barely soiled loads.
Press to add 18 minutes of soaking time at the start of the wash
cycle for better stain removal.
Press to add an additional rinse at the end of the cycle for more
thorough removal of laundry additives and perfumes.
Press to shorten the washing time of the NORMAL, HEAVY DUTY
or WHITES cycles. Shortened time may differ depending on the
cycle, load, and options.
Set the washer to finish your wash automatically at later time.
Choose a delay of between 1 to 24 hours (in 1 hour increments).
(For more information about Delay End, see page 44.)
2019-06-24 PM 12:08:01