Dyna-Glo DGF350CSP Manual De Instrucciones página 24

CARE AND MAINTENANCE
Burner Assembly
Removing The Burner Assembly
1. Make sure all control knobs are in the OFF
position, gas supply valve is closed, and the
gas hose is disconnected from the gas supply.
2. Open lid and remove warming rack, cooking
grates, heat tents, clip for burner, ignition
chain and main burner.
3. Remove hinge pin as illustrated in Figure 1.
4. Slide main burmers out of firebox.
5. Detach ignition wire from electrode in Figure 2.
Figure 1
Figure 2
24
Warming Rack
Cooking
Grates
Heat Tents