Mitsubishi AL2-10MR Manual Del Usuario página 103

α
2 Simple Application Controllers
Table 14.4: Function Block Lists
Function Block
Name Symbol
Short
Message
SMRm
Receiving
Maintenance
Call Detect CD
Call Detect
CDm
Maintenance
Random One
ROS
Shot
Delayed One
DOS
Shot
Delayed
DAL
Alternate
Retentive
RSR
Set/Reset
Proportional
PID
Integral Gain
Analog
AO
Output
Control
CDP
Display
Memory
Consumption
(Byte)
Output change by Short Message
The function block can be setup from
*7
the TopMenu "Parameter" via the
front panel keys.
Calling Line Identification
30 Presentation (CLIP) Phone number
detection
Calling Line Identification
Presentation (CLIP) Phone number
detection
30
The function block can be setup from
the TopMenu "Parameter" via the
front panel keys.
The random length single pulse is
19
output.
After a delay time, send a single
20
pulse
After a delay time, output alternates
16 turning ON or OFF with each input
pulse
Latch a relay in SET or RESET
position, give Set or Reset priority.
The last output status is kept when
the power supply is cycled OFF and
14
ON.
However, last output status is lost
when the
Stop mode.
The PID Function Block is the
implementation of PID, a control
method used to obtain stable control
over a system variable. It is a
52
equipped with an Auto-tuning
function, which automatically adjusts
the Function Block parameters for
the specific application.
The Analog Output function takes a
digital value input and delivers a
17 corresponding analog voltage or
current to a selected channel on the
AL2-2DA module.
Control which Display screen
appears on the LCD. This function
block can only be set in the AL-PCS/
*6 WIN-E software.
When control bit N04 is ON, it
possible to control the displayed
User Screen.
Key, System Bit and Function Block Lists 14
Description
α
2 series is placed in the
α
2
AL2-14MR-*
AL2-10MR-*
AL2-24MR-*
ENG-89
ENG