Bestron DFT25R Manual Del Usuario página 20

opeRATIon - General
The appliance is intended only for domestic use, not for professional use.
9c 9b 9a
14
Figure 1
1. Handle
2. Oscillation button
3. Speed control: OFF-I-II
4. Rod
5. Motor housing
6. Locking screw
7. Base
opeRATIon - before use for the first time
Remove the fan from the packaging and remove all packaging materials.
opeRATIon - Assembling
1. Unscrew the 4 screws (9a) and the insulation rings (9b and 9c) from the housing.
2. Fit the rear of the fan housing (with the grip) (10) onto the motor-housing shaft, making sure that the
grip is at the top.
3. Fasten the rear fan housing by four screws (9a). Make sure the insulation rings (9b and 9c) are placed
as depicted in figure 1.
4. Slide the fan blades (11) onto the shaft, making sure that the notches are aligned precisely with the two
keys on the shaft, and screw it.
5. Press the front half of the fan housing into the rear part (12) of the fan housing and tighten with the
grips (13).
opeRATIon - Ventilation
1. Set the fan on a level surface, such as a table.
2. Tilt the fan to the required angle (see Figure 2). You can set the fan:
a. to blow horizontally (position A) or angled slightly downwards (position B). Turn the locking screws
a little bit loose first (see figure 2) Tilt the ventilator housing and motor housing to the required
angle. (with a sweep of 10°). Tighten the locking screws again.
2
4
3
5
6
20
user's instructions
1
9
11
10
7
8
8. Non-slip feet
9. Screws and insulation rings
10. Fan housing (front part)
11. Fan blades
12. Fan housing (rear part)
13. Grips
14. Power cord and plug
13
12