VMB TE-064 Manual De Instrucciones página 11

Operating instructions
4.6 - Lowering:
The manoeuvre of lowering is obtained
by the opposite way. Lift the blockade on the
safety catch (M3) and rotate the hand crank of
the winch in a counterclockwise (N
the load until that the third profile would be
completely folded. Lift the blockade on the
safety catch (M2) and continue lowering the
tower until that this second profile would be
completely folded. Lift the blockade on the
safety catch (M1) and continue lowering the
load until that the tower would be completely
folded down to its minimum height.
The tower can be left in any intermediate
position wich would be necessary, the same
as lifting the load.
4.7 - For the transport of the tower is necessary
to fold the tower lowering completely all the
profiles, blockading them with the safety
catches (M1, M2, M3). Get out the legs lifting
the blockade on the catches and put them in
their transport lodging (S).
5. MAINTENANCE
5.1 - The cable is to be regulary checked for
wear (ie: kinks, single strund breakage). Faulty
) lowering
cables must be replaced immediately. Do not
2
use the elevator tower with faulty cables.
Only use handle cables DIN 3060.
5.2 - The elevator tower has been lubricated in
the workshop. It is nevertheless recommended
that oil is regulary applied to the gear drive, the
bearing bushes on the drive shaft and to the
drum hub, the thread of the handle and the
sections of the tower.
ATTENTION:
Do not apply oil or grease to the brake
mechanism.
The brake washers have been
pregreased with an special warmth and
pressure resistant grease. Do not use other
greases as this will effect the winch brake
performance.
It is not necessary greasing the brake
washers.
5.3 - The elevator tower TE-064 must be
inspected by trained personnel at least once
annually.
5.4 - In order to maintain this guarantee of
function and safety, original parts of the
manufacturer's design must be used.
The user forfeits all rights to claim if parts
other than those of the manufacturer are used
or modifies the product in any other way.
5.5 - When any spare part would be required,
it is necessary to indicate its reference number,
wich is included in the spare parts of this
manual.
-
ENGLISH
www.audiovias.com