HyperIce Normatec 2.0 Pro Instrucciones De Operación página 10

ADJUST THE SESSION TIME
Adjust the session time by pressing the time adjustment buttons on the left and right of the time indicator. The session
time can be set between 10 minutes and 2 hours and 55 minutes (in 5-minute increments). A typical session time is
between 15 and 60 minutes long. Setting the time longer than 2 hours 55 minutes will put the control unit into Continuous
Mode. To turn off Continuous Mode, decrease the time. In Continuous Mode, the screen will display CONTINUOUS
instead of the timer, and will begin counting up from zero when the session starts. Time can be adjusted while the session
is running. Tap the time adjustment buttons to add or subtract time from the session in 5-minute increments.
TURN OFF BLUETOOTH WIRELESS TECHNOLOGY
To disable Bluetooth wireless technology on the device, press and hold the Bluetooth button on the top of the device for
ten seconds. The Bluetooth icon will disappear from the screen when it is disabled.
START THE SESSION
To start the session, tap the start button on the home screen.
STOP OR PAUSE THE SESSION
To stop the session at any time, tap the pause button on the home screen. This will temporarily stop the session. To
resume a paused session, tap the resume button. To end a session, tap the pause button and then tap the quit button. If
you are done using the system, remove the attachments from the hose, remove the attachments from your limbs, turn off
the control unit by pressing the power button, and disconnect the hose from the control unit.
To disconnect connectors from the junction box or the control unit, push the button on the top of each connector while
pulling away.
FINISH THE SESSION
The session will continue massaging until the time on the home screen reads 00:00:00 and the current cycle is completed.
While the current cycle is being completed, cycle finishing will be displayed on the home screen. To stop the session
immediately, tap the stop button. To extend the session, tap the
the session is complete, the control unit will reset to the original session time. When the session is completed, remove
the attachments from the hose, remove the attachments from your limbs, turn off the control unit by pressing the power
button, and disconnect the hose from the control unit.
To disconnect connectors from the junction box or the control unit, push the button on the top of each connector while
pulling away.
10
button to the right of the time to add minutes. Once