POWER 6STANDBY/
s STOP/SET/CLEAR
f, g
B
CD OPERATION
1
Press CD.
The power is turned on.
2
Press PUSH OPEN to open the disc
compartment. Place a disc with the
printed side up and close the disc
compartment.
Total number of tracks and total playing time are
displayed. It will take about 15 seconds when
loading a CD-RW disc.
3
Press e PLAY/PAUSE to start play.
The number of the track being played and elapsed
playing time are displayed.
s STOP/SET/CLEAR * – Stops play.
* or s STOP on the remote control (CSD-FD89/79
only)
e PLAY/PAUSE – Pauses play. To resume play,
press again.
f, g – Searches for a particular point during
playback. Hold down f or g and then release it.
– Skips to the beginning of a track. Press f or g
repeatedly.
8
ENGLISH
ON
PUSH OPEN
To select a track directly with the remote control
(CSD-FD89/79 only), press the numbered buttons 0-9
and +10. CD play starts from the selected track and
continues to the last track.
Example:
To select number 25, press +10, +10 and 5.
To select number 10, press +10 and 0.
After listening, press POWER 6 STANDBY/ON to turn
the power off.
NOTE
• Do not use irregular shape CDs (example: heart-
shaped, octagonal ones).
It may result in malfunctions.
• Do not place more than one disc in the disc
compartment.
• Do not try to open the disc compartment during play.
• Do not touch the lens. Doing so may cause
malfunctions.
• The unit may not play a CD-R/RW disc that is
recorded on personal computers or some kinds of
CD-R/RW recorders because of differences in
recording platforms.
• Do not attach any seal or label to either side (the
recordable side or the labeled side) of a CD-R/RW
disc. It may cause malfunction.
• Do not load an unrecorded CD-R/RW disc. It will take
over 30 seconds to read the disc. The disc may be
damaged if you try to open the disc compartment
while reading the disc.
REPEAT/MODE/
SLEEP
CD
e PLAY/PAUSE