OHAUS VN Serie Manual De Instrucciones página 9

VN Series Floor Scale
INSTALLATION OF OPTIONAL FOOT PLATES AND RAMPS
Installation of each Ramp also requires the installation of one set of Foot Plates. Foot Plates are available separately and are
included with the Ramp accessory kit. Refer to Figure 5 for mounting of the Foot Plates and Ramps. Installation of Floor Plates
and Ramps must be done before final placement of the Floor Scale.
LEGEND: 1.Foot Plate, 2. Bolt, 3. Spring Washer, 4. Washer, 5. Expanding Bolt, 6. washer, 7. Nut
Notes: 1. Expanding bolts require 12.5mm (0.5") diameter holes drilled 60mm (2.4") deep into the floor surface.
2. Foot Plate center to center dimensions W and L are shown in Table 6.
3. The Floor Scale must be positioned so that the load cell feet rest within the large holes of the Foot Plates.
4. Ensure that a free air gap exists between the sides of the Floor Scale and the edges of the Ramps.
MODELS
Ramp for VN5000L
Ramp for VN5000X
Figure 5. Optional Foot Plate and Ramp Installation
TABLE 6. DIMENSIONS FOR FLOOR PLATE AND RAMP INSTALLATION
A
4' / 1220 mm 26.4" / 670 mm
5' / 1524 mm 26.4" / 670 mm
H
DIMENSIONS
RAMP
B H
3.56" / 90.5mm
3.56" / 90.5mm
FOOT PLATE CENTERS
W
43.7" / 1110 mm 43.7" / 1110 mm
55.7" / 1414 mm 55.7" / 1414 mm
EN-7
L