Bevel Cutting; Adjusting Depth Of Cut - Makita XSS01 Manual De Instrucciones

Sierra circular inalámbrica
Ocultar thumbs Ver también para XSS01:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Indicator lamps
Lighted
Off
015658
NOTE:
Depending on the conditions of use and the
ambient temperature, the indication may differ
slightly from the actual capacity.

Adjusting depth of cut

1
006701
CAUTION:
After adjusting the depth of cut, always tighten the
lever securely.
Loosen the lever on the side of the rear handle and
move the base up or down. At the desired depth of cut,
secure the base by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for dangerous
KICKBACKS which can cause personal injury.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
1. Lever

Bevel cutting

1
006702
For Model XSS01
0-45
1
XSS01
013951
Loosen the lever on the bevel scale plate on the front
base. Set for the desired angle (0° - 50°) by tilting
accordingly, then tighten the lever securely. Use the 45°
stopper when you do precise 45° angle cutting. Turn the
stopper counterclockwise fully for bevel cut (0° - 45°)
and turn it clockwise for 0° - 50° bevel cuts.
For Model XSS02
Loosen the lever on the bevel scale plate on the front
base. Set for the desired angle (0° - 50°) by tilting
accordingly, then tighten the lever securely.
Sighting
B
006704
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.
8
1. Lever
1. Stopper
0-50
1. Base
2. Cutting line
1
2
A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Xss02

Tabla de contenido