The machine will emit a prolonged acoustic signal, then the:
On/Stand-by
and FREE DOSE
descaling warning lamp will all come on to a steady light .
Press the FREE DOSE button
cycle.
If the FREE DOSE button
minutes after the acoustic signal has been emitted, the
machine will go back to the "Stand-by" mode and the step
in the procedure shall be repeated, to start the cycle.
The machine will activate the heating phase and the
FREE DOSE button
The machine will automatically activate the descaling
process, after the heating cycle is over.
During the descaling cycle, the FREE DOSE button
be ON and blinking and the descaling warning lamp
ON to a steady light.
MAINTENANCE AND CLEANING
buttons and the
to start the descaling
is not pressed within 9
will start blinking.
will be
During the descaling cycle, the machine will auto-
matically perform intermittent supply cycles, to
allow the container to be emptied.
The descaling cycle can be temporarily interrupted by
pressing either the FREE DOSE button
by button
DOSE button
The cycle will be temporarily interrupted when the fluid
runs out in the machine tank. Empty the container used
to collect the solution.
On/Stand-by
warning lamp
warning lamp
Remove the water tank, rinse and wash it accurately. Fill
will
it with drinking fresh non-carbonated water up to the
MAX. level.
In case of power supply interruption, the machine will,
upon the first power-on, request the rinsing cycle.
Fit the tank with water. Place a container with a capac-
ity of at least 0.5 litres under the supply device.
Press the FREE DOSE button
cycle.
To end the rinsing cycle, a minimum amount of water will
have to be supplied. In case of lack of water, the cycle will
be temporarily interrupted, the machine will emit a pro-
longed acoustic signal and the "No water" warning lamp
will come on to a steady light. Top the tank up.
Then the supply has been completed, clean the ma-
chine by means of a moist, soft cloth. After cleaning
the machine, the descaling process will be over. The
machine will be ready for use.
45
. To start the cycle again, press the FREE
.
, FREE DOSE button
will be ON to a steady light. Descaling
will be ON and blinking.
to start he rinsing
E N
On/Stand-
and "No water"