Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe PuraVida 15275400 Modo De Empleo/Instrucciones De Montaje

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• If the water is flowing along the fixture in the
direction of the shaft, the spray former must be
replaced with a standard air bubbler 95928000.
• The drain valve must only be used as intended. It is
not allowed to attach other objects to the drain
valve, for example a semi-pedestal.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!
4
max. 1 MPa
0,25 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 60°C
70°C / 4 min
Assembly (see page 32)
English

Symbol description

Do not use silicone containing acetic acid!
Dimensions (see page 35)
Flow diagram (see page 35)

Rate of flow mixer

Rate of flow handshower
Spare parts (see page 39)
Cleaning (see page 36)
Operation (see page 34)
• Hansgrohe recommends not to use as drinking water
the first half liter of water drawn in the morning or
after a prolonged period of non-use.
• Due to the design of the Bidette fittings, a small
amount of water will leak at the outlet of the fitting
when the hand shower is running.
Test certificate (see page 40)