Switch Action; Speed Adjusting Dial - Makita XBP04 Manual De Instrucciones

Switch action

WARNING:
Before installing the battery cartridge into
the tool, always check to see that the switch trigger actuates
properly and returns to the "OFF" position when released.
WARNING:
NEVER defeat the lock-off button
by taping down or some other means. A switch with
a negated lock-off button may result in unintentional
operation and serious personal injury.
WARNING:
NEVER use the tool if it runs when you
simply pull the switch trigger without pressing the lock-off
button. A switch in need of repair may result in unintentional
operation and serious personal injury. Return tool to a Makita
service center for proper repairs BEFORE further usage.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
depress the lock-off button and pull the switch trigger.
Tool speed is increased by increasing pressure on the
switch trigger. Release the switch trigger to stop.
1
2
► 1. Lock-off button 2. Switch trigger

Speed adjusting dial

► 1. Speed adjusting dial
The tool speed can be infinitely adjusted between 1.3
m/s (260 ft/min) and 3.2 m/s (630 ft/min) by turning the
adjusting dial. Higher speed is obtained when the dial
is turned in the direction of number 6; lower speed is
obtained when it is turned in the direction of number 1.
Select the proper speed for the workpiece to be cut.
NOTICE:
to "1", turn the dial counterclockwise. Do not turn
the dial clockwise forcibly.
NOTICE:
ting at high speeds.
Lighting up the front lamp
CAUTION:
source of light directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately 10 seconds after
releasing the switch trigger.
► 1. Lamp
NOTE: Do not apply impact to the lamp, which may
cause damage or shorted service time to it.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: When the tool is overheated, the lamp blinks
for one minute, and then goes off. In this case, cool
down the tool before operating again.
ASSEMBLY
1
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
7 ENGLISH
When changing the speed dial from "6"
Plastic materials may melt when cut-
Do not look in the light or see the
1
Always be sure that the tool is