Parts And Operating Controls; Using A Generator Or Transformer - Hilti DD 120 Manual De Instrucciones

3.2

Parts and operating controls

3.2.1 Vacuum base plate (accessory)
Clamping spindle
R
Vacuum hose connector
T
Pressure gauge
Z
3.2.2 Fastening accessories
Clamping spindle
O
Anchor
P
3.2.3 Water collection system
Water collector holder
[
3.3 Service indicator
The product is equipped with a service indicator LED.
3.4 Items supplied
Diamond core drilling machine, hand wheel, operating instructions.
The drill stand is supplied as a separate unit. Other system products approved for use with this product can
be found at your local Hilti Store or at: www.hilti.group.
3.5

Using a generator or transformer

This machine can be powered by a generator or transformer when the following conditions are fulfilled:
The generator or transformer's power output must be at least twice the rated input power shown on the
machine's type identification plate, the operating voltage of the transformer or generator must always be
within +5 % and -15 % of the machine's rated voltage and the frequency must be 50 to 60 Hz and never
above 65 Hz and the transformer or generator must have automatic voltage regulation with starting boost.
26 English
Printed: 09.08.2019 | Doc-Nr: PUB / 5069516 / 000 / 07
1
DD 120 diamond core drilling system
@
;
=
%
&
(
)
+
§
/
:
∙
$
£
|
¡
Q
W
E
2
U
I
3
Ü
4
]
Theft protection indicator (optional)
Service indicator
Drilling performance indicator
On/off switch
End stop
Rail
Hand wheel
Adjusting screws for carriage play (4x)
Carriage lock
Carriage
Anchor base plate
Leveling screws (4x)
Chuck
Water swivel
Gear switch
Gearing section
Motor
Carbon-brush cover
Supply cord with PRCD
Vacuum relief valve
Vacuum seal
Clamping spindle nut
Water collector
274865
*274865*