Publicidad
RADIO CONTROLLO / REMOTE CONTROL / TELECOMMANDE /
INSTRUCTIONS FOR STARTING AND USING THE MACHINE WHEN BATTERY POWERED
ATTENTION The machine has a range of approximately 1,5 hours when only using battery power.
In order to transport the machine on the work site, the following procedures
1. Make sure that the 3rd wheel has been correctly positioned and locked. [
2. Make sure that the general switch on the panel is positioned on "1" (only when using power on line) [
3. Make sure that the mushroom shaped emergency botton on the panel and the one of the remote control/wired
remote control are not pressed.
4. Turn the
DISCONNECT BATTERY KEY
5. Check that the power level of the batteries is above 50%. Otherwise proceed to
6. If the machine is not connected to the electrical circuit net, the light "Anomalia fasi" will turn on (orange light) [
Photo 2-A].
7. The
BATTERY INSERT LIGHT
8. Wait until the "Reset Emergency"(red light) flashes [
9. Press and keep pressed for about 3 sec the reset botton on the right side of the remote[
you should here a clicking sound coming from the Battery area of the machine. A green light will also light up on
the remote [
Photo 4-V].
The machine is now ready for use. If it does not function check the paragraph on "P
10. Raise the machine completely [
11. Select the desired speed on the remote control according to the slopes and the distances to be covered, as well as
the presence and the positions of eventual obstacles[
12. Move the machine as required using the joystick on the remote control [
:
NOTE
Lack of use of the remote control for more at least 3 min. will cause disactivation (green light will turn on)
[ Photo 4-V]. In the event repeat procedure n. 9 in order to reactivate.
ATTENTION
Make sure that persons or animals are not in the range of the work area of the machine. The operator must position
himself and be at a distance in order to keep under control the space around the work area range of the machine.
ATTENTION Disregard of any of the above listed procedures, releases the producer/provider from any responsibility.
Anyone that uses the machine must assess that all the relative dispositions of law and/or permissions to the use are
respected. The operator must also assess of the security conditions such as:
range of the machine
b) sufficient electrical power
FERNBEDIENUNG / CONTROL REMOTO
[Photo 2-H / Photo 4-H]
to the ON position. [
turns on (blue light) [
Photo 6] using the appropriate lever on the remote control [
Data ultimo aggiornamento: 15/09/2013
MUST BE ABSOLUTELY
Photo 3].
Photo 2-C]. The inverters vacuum fan will turn on.
Photo 2-D].
Photo 4-S].
c) absence of explosive, inflammable or corrosive materials.
executed:
Photo1].
CHARGE THE BATTERY
Photo 5]; once released
S
ROBLEM
OLUTIONS
Photo 4-U].
Photo 4-F].
a) absence of persons or animals in the
Photo 2].
. [
Foto 2-P].
".
Pag. 17 di 32
Publicidad
