Resistance Measurement - Steren MUL-650 Manual De Instrucciones

RESISTANCE MEASUREMENT

Connect the black test cable in to the COM terminal and the red test cable in to the V Ω Hz terminal.
1
Turn the knob to the
2
Tap the circuit with tips. The measurement value will be displayed.
3
NOTES:
1. If you measure resistors greater than 1 MΩ, the Meter may take a few seconds to obtain a stable reading.
2. When the terminal is not connected, it means, in open circuit, the"OL" icon will be displayed indicating that it is over the range.
3. Make sure that the circuits are out of power and capacitors are fully discharged to prevent electrical shock or damage to the
device.
CAPACITY MEASUREMENT
Connect the black test cable in to the COM
1
terminal and the red test cable in to the V Ω Hz
terminal.
Turn the knob to the
2
3 Tap the circuit with tips or wire that you
want to check. The measurement value
will be displayed.
NOTE:
Make sure that the circuits are out of power and the capacitors are fully discharged to prevent electric shocks or damages to the
device.
position.
SELECT HOLD RANGE REL
Hz
Hz
(IL 25mA)
A
V
mA
OFF
A
20A
V Hz
MAX 10 SEC.
A
CAT.IV 600V
mA CAT.III 1000V
COM
T
20A MAX FUSED T
400 mA MAX FUSED
position.
Red cable
Black cable
SELECT HOLD RANGE REL
Hz
Hz
(IL 25mA)
A
V
mA
OFF
A
20A
V Hz
MAX 10 SEC.
A
CAT.IV 600V
mA CAT.III 1000V
COM
T
20A MAX FUSED T
400 mA MAX FUSED
Red cable
Black cable
8