Uline JUMBO H-1871 Manual Del Usuario página 4

5. Attach the sill (8) to the sides. Place nuts loosely on
each of the studs and slide the ends of the sill into
the slots on both sides of the unit. Then securely
tighten with nuts. (See Figure 5)
8
Slide studs into the slots
located near the bottom
of each side panel.
6. Place a shelf (5) into the four lowest shelf supports in
the back. The front of the shelf will rest on the sill.
(See Figure 6)
5
8
PAGE 4 OF 15
ASSEMBLY CONTINUED
7. Using two people, set unit upright and tighten all
Figure 5
8. Attach the left door (6) to the unit. Place the door on
Figure 6
9. Repeat Step 8 for the right door (7).
10. Adjust the levelers underneath the front of the unit
nuts and bolts. Insert the remaining shelves. Be sure
the shelf edge with no slots faces the cabinet front.
The slots on the other three sides fit over the shelf
supports on the cabinet walls, which hold the shelf
in place.
NOTE: To ease shelf installation, have second
person apply slight pressure to the back
panels from behind the cabinet, while other
person installs shelves.
the hinges, align the holes, and drive the four hinge
pins (11) into place. (See Figure 7)
11
6
NOTE: If having issues with doors aligning, it
may be due to cabinet not sitting level. Use
included nut driver to adjust leveling feet in
bottom front two corners. Nut driver should
insert through inside of cabinet down into feet
and adjust as needed.
to ensure the cabinet is leveled.
NOTE: The doors will not align properly if the
cabinet is not leveled.
SEE NEXT PAGE TO ATTACH HANDLE
Figure 7
7
0221 IH-1871