NORTH STATES 5323 Manual De Instrucciones página 4

• To add an extension, begin by removing both the upper and lower
Step 2
plugs from the side of the gate frame. You may need to use a athead
screwdriver to remove the plugs. Figure 2A.
• Attach both the upper and lower adapters to the extension pole.
• Install the fully assembled extension by inserting the upper and lower
extension adapters into the gate in the holes where you removed the
plugs. Figure 2B.
• Reinsert both plugs, then insert the bolts with rubber pads into the
holes on the outside of the extension. Figure 2C.
2A
Upper plug
Lower plug
IMPORTANT: When installing multiple extensions, place as equally as possible
on either side of gate frame. The 1-Bar Extension must be inserted into gate
frame before adding an additional extension.
2B 2C
Page 4