Storage And Transport - DBI SALA 3M 8000089 Manual De Instrucciones

6.0 MAINTENANCE, SERVICING, STORAGE
6.1 CLEANING: Periodically clean the HC Davit Base's metal components with a soft brush, warm water, and a mild soap
solution. Ensure parts are thoroughly rinsed with clean water.
6.2 SERVICE: Only 3M or parties authorized in writing by 3M may make repairs to this equipment. If the HC Davit Base has
been subject to fall force or inspection reveals an unsafe or defective conditions, remove the system from service and
contact 3M regarding replacement or repair.
6.3 STORAGE AND TRANSPORT: When not in use, if applicable, store and transport the HC Davit Base and associated fall
protection equipment in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may
exist. Thoroughly inspect components after extended storage.
7.0 LABELS
Figure 5 illustrates labels on the HC Davit Base. Labels must be replaced if they are not fully legible. Information provided on
each label is as follows:
Read all instructions.
CE Standards
1
AS/NZS Standards Certification
2
A) Maximum Davit Arm Offset B) Personal Fall Arrest System (PFAS) Maximum Arresting Force (MAF) ≤ 6 kN (1,350 lbs)
3
C) Maximum Material Handling Capacity
A) Manufactured (Year, Month) B) Model Number C) Serial Number
4
8