Gamma Piu GPTCTS Manual De Uso Y Garantía página 13

Using the distance comb
Check that the appliance is off.
Place the comb D (fig. 1) on the cutting edge of the head A (fig. 1) and press it until it
engages the lower part of the head itself, by applying force towards the handle (fig. 2).
• Turn on the device.
• Cut the hair; for tips see par. "USEFUL CUTTING TIPS".
Removing the distance comb
• Turn off the appliance.
• Unhook the comb from the blade base and slide it off the appliance.
Use without the distance comb
When using the appliance without the adjustable guide comb D (fig.1),
the blade of the head A (fig.1) will cut the hair very close to the skin.
Do not use the appliance if the blades of the head A (fig.1) are
damaged or if the blade block is not working correctly.
The appliance can be used without the guide comb D (fig. 1) to cut hair very close to the
skin or to redefine the hairline of the neck and around the ears.
MAINTENANCE
In case of malfunction or damage to the appliance or a part of it, the
appliance must be analysed by the manufacturer or the relevant
technical assistance or in any case by a person with similar skills in
order to prevent any risk. The user must not disassemble the device
him/herself.
GENERAL CLEANING
It is recommended to clean daily or after every use.
Check that the appliance is off and disconnected from the power mains.
• Avoid all risk of electric shock by not cleaning the appliance with water and
do not immerse it in water.
• Do not use abrasive solutions or concentrated detergents.
• Clean the exterior with a soft cloth or slightly damp cloth.
• After use, make sure that all parts are completely dry.
Removing and cleaning the blade block
• Turn off the appliance.
• Remove the hair residues from the head using the brush F (fig. 1).
• Lubricate the head with the special oil (Fig. 5).
• Turn on the appliance briefly to ensure an even distribution of the oil film.
For thorough cleaning the head must be unscrewed.
Maintenance, replacement and adjustment of the head
The head components can be sharp. Take particular care during the
whole procedure.
• Use a suitably sized screwdriver to remove the screws from the head A (fig. 3).
• Unhook the head by levering in the special groove R (fig. 3) located below the head.
• Remove the mobile blade O (fig. 4) from the side to release it from the fixed blade
N (fig. 4).
13