Gamma Piu GPTCTS Manual De Uso Y Garantía página 14

• Clean all the parts from any remaining hair.
• Lubricate the head with the special oil (fig. 5).
• Reassemble by re-inserting the mobile blade.
• Re-attach the head to the supports, making sure that the metal springs Q (fig. 4)
correctly engage in the grooves S (fig. 4) of the blade holder P (fig. 4).
• Tighten the screws to firmly attach the head to the body.
To be able to adjust the cutting length of the head, you can change the distance
between the fixed blade N (fig. 4) and the mobile blade O (fig. 4).
• After unscrewing and releasing the head, loosen the internal screws T (fig. 4).
• Move the blade until you reach the desired distance a (fig. 4).
• Before tightening the screws, check that the mobile blade is aligned laterally to
the fixed blade (Fig. 4 – b/c) and align the fixed blade so that between the front
edge of the comb and the front edge of the mobile blade there is a minimum
distance of 0.1-0.5 mm (Fig. 4 - a) to prevent the risk of skin injuries when using
the appliance
• Firmly tighten the internal screws T (fig. 4).
• Re-check the alignment of the fixed blade and repeat again if the alignment is
not optimal or safe.
• Re-attach the head of the body as previously explained.
• Before using the appliance, check that it is working properly.
Lubrication
It is recommended to lubricate the blade unit daily or after every use.
To ensure that the cutting blade remains sharp, the cutting head must be lubricated.
It is recommended to regularly apply two to three drops of lubricant E (fig. 1) directly
on the blade (fig. 5).
If after a long period of use, and despite constant cleaning and oiling,
the cutting performance decreases, the head must be replaced.
Failure to lubricate the appliance is considered as "FAILURE TO COMPLY WITH
THE INSTRUCTIONS FOR USE", therefore, the warranty will be automatically
rendered null and void.
DISPOSAL
The product packaging is made of recyclable materials. Separate the parts
according to their type and dispose of them in accordance with applicable
laws on the environmental protection.
INFORMATION TO USERS in accordance with Legislative Decree No.49
of 14 March 2014 "Implementation of Directive 2012/19/EU on waste
electrical and electronic equipment (WEEE)"
The crossed bin symbol on the appliance indicates that at the end of its life-
span, the product must be collected separately from other waste. The user
must deliver the appliance, with the essential components, at the end of its
life-span, to the appropriate separate collection centres for electronic and
electrotechnical waste, or return it to the dealer when a new applicable of
equivalent type is purchased, at the rate of one to one, or 1 to zero for
14