Disposal; Troubleshooting; Technical Specifications; Replacement Parts And Wearing Parts - Beurer SI 40 Instrucciones De Uso

• Store the device in a dry place, ideally in the original
packaging.

7. Disposal

For environmental reasons, do not dispose of the de-
vice in the household waste.
Please dispose of the device in accordance
with EC Directive – WEEE (Waste Electrical and
Electronic Equipment).
If you have any questions, please contact the
local authorities responsible for waste disposal.

8. Troubleshooting

Problem/ Possible cause/remedy
question
The ON/ 1. Check the power connection to
OFF switch the socket and check whether
has been the mains plug has been
plugged in correctly.
switched
on, but the
2. The device has a thermal fuse.
device is not
Following switch-off, the mains
working.
plug must be pulled out and a
waiting period observed (see the
section on fuses in Chapter 3
„Warnings and safety notes").
The device is 1. Check that there is water in the
switched on container of the water heater
but produces tank.
no or hardly
2. Check that there is liquid in the
any steam.
aroma container.
3. Make sure that the suction tube
and other components have
been attached properly.
4. Check the nozzle for blockages.
Clean the nozzle if necessary
(see "Cleaning the nozzle"
section in the "Cleaning and
disinfection" chapter)
Does every- Yes, this is absolutely essential for
hygiene reasons.
one need
a separate
mask?

9. Technical specifications

Model SI 40
Dimensions
(W x H x D) 265 x 260 x 96 mm
Weight
620 g
Filling volume
of internal water
heater Max. 25 ml
Aroma container
filling volume Max. 60 ml
Mains connection 220 – 240 V~; 50 – 60 Hz
Steam
Approx. 43°C
temperature
Water boiling time Approx. 2 minutes
Maximum
Approx. 10 minutes
operation time
Operating Temperature: +10°C to +40°C
conditions Relative humidity: 10% to 95%
Ambient pressure: 700 hPa to
1060 hPa
Storage and Temperature: 0°C to +60°C
transportation Relative humidity: 10% to 95%
conditions Ambient pressure: 500 hPa
to 1060 hPa
Subject to technical changes.
Please contact the specified service address to ob-
tain further information, such as the CE Declaration
of Conformity.
10. Replacement parts and
wearing parts
Designation
Mask

11. Warranty / service

Beurer GmbH, Söflinger Straße 218, 89077 Ulm, Ger-
many (hereinafter referred to as "Beurer") provides a
warranty for this product, subject to the requirements
below and to the extent described as follows.
16
Material REF
PVC 601.34