Connection To Your Amplifier - Yamaha Soavo-900M El Manual Del Propietario

Before making connection, make sure that the amplifier is switched off.
• Connect the screw-type terminals at the rear of the
speakers to the speaker terminals of the amplifier with
the speaker cable (sold separately).
• Connect the (+) terminals on the amplifier and the
speakers using one side of the cable. Connect the (–)
terminals on both components using the other side of the
cable.
• Connect one speaker to the left (L) terminals of your
amplifier, and another speaker to the right (R) terminals,
making sure not to reverse the polarity (+, –). If one
speaker is connected with reversed polarity, the sound
will be unnatural and lack bass.
How to connect:
1
Loosen the knob.
2
Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
Good
( 3/8" )
3
Insert the bare wire into the hole.
4
Tighten the knob and secure the cable.
Test the firmness of the connection by pulling lightly on
the cable at the terminal.
Notes
• Do not let the bare speaker wires touch each other as
this could damage the speaker or the amplifier, or
both of them.
• Do not insert the insulation coating into the hole.
The sound may not be produced.
When using a banana plug
1
Unscrew the terminal knob.
2
Remove the cover by pulling it toward you.
2
1

CONNECTION TO YOUR AMPLIFIER

No Good
Loosen
Black (–)
Bare wire
Soavo-900M
(R)
SPEAKERS
R
Speaker
terminals of
+ –
the amplifier
Amplifier
3
Tighten the terminal knob.
4
Simply insert the banana plug into the terminal.
4
Banana plug
Tighten
Red (+)
Insulation coating
Soavo-900M
(L)
L
A
– +
B
3
3
En