Cleaning And Maintenance - Team International TEAM WK 35 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
Fax +32 2 359 95 50
OPERATION
Always remove the jug from the power base before filling it.
Raise the lid and fill the tank with fresh water paying attention not to fill under the "MIN"
mark and above the "MAX" mark in the kettle. You can see the level thanks to the
transparent water level indicator.
Close the lid by pressing it down until you hear a click. Make sure it closes correctly.
Put the jug onto the power base, plug into the wall socket and switch on. The pilot light will
come on. If it does not come on, check if the jug kettle is placed correctly on its base. If the
problem persists, contact the nearest customer service.
The jug kettle will switch off automatically when the water is boiling. However, you can
switch it off anytime by pressing the on/off switch.
For instant reboiling, wait until the water has cooled down and switch on the appliance
again.
SAFETY CUT-OUT
This jug kettle is protected with an automatic safety device which switches the appliance
off if it is accidentally switched on without water.
In this case, put the switch in off position and wait about 10 minutes for the element to
cool. Then fill the jug kettle with cold water. This will reset the safety device.
The kettle may then be used as normal.
Should the problem persist, please contact the nearest customer service.

CLEANING AND MAINTENANCE

Before attempting any cleaning operation, make sure the appliance is unplugged from
the supply socket and fully cooled down.
To clean the exterior surfaces, simply wipe over with a soft damp cloth and dry thoroughly.
To remove scale from the inner walls of the kettle and from the filter you can use a soft
brush.
Never use abrasive products.
On no account must the jug kettle or its power base be immersed in water.
FILTER
Your appliance is provided with a filter. When you want to boil water, settle the filter first.
When the lid is open, you can remove the particle filter by pulling it and clean it under
running water.
The filter should be rinsed clean regularly.
DESCALING
To remove scale from the jug kettle, use products made especially available for this purpose.
Make sure to use a type recommended for plastic kettles and follow the product's instruction
manual carefully.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
8
Assembly page 8/40
TEAM WK 35 - 150113

Publicidad

Tabla de contenido
loading

Tabla de contenido