Installing The Dust Bag; Installing The Vise Clamp - Skil 3316 Instrucciones De Funcionamiento

SM 2610017175 08-11:SM 2610017175 08-11.qxp 8/2/11 11:24 AM Page 28

Installing the Dust Bag

1. With the miter arm locked in the down position, compress
the two tabs on the spring clip and slide the bag over the
rib on the dust port (Figure 5) then release the tabs.
2. Position dust bag so that it does not interfere with the tool
during the cutting operation for all miter/bevel settings.
3. The dust bag requires emptying when full of sawdust.
Empty it frequently and after completion of sawing.
Carefully remove dust bag from dust elbow to empty. Be
extremely careful of dust disposed, materials in fine
particle form may be explosive. Do not throw sawdust on
an open fire. Spontaneous combustion, may in time,
result from mixture of oil or water with dust particles.
WARNING
any other materials that may contain carcinogens, use special
precautions. A suitable respirator must be worn by all
personnel entering the work area. Work area should be sealed
by plastic sheeting and persons not protected should be kept
out until work area is thoroughly cleaned.

Installing the Vise Clamp

Install the vise clamp 1 in the mounting hole 2 provided on
either side of the base front (Figure 6).
Assembly
When sawing chemically pressure treated
lumber, paint that may be lead based, or
2
28
FIG. 5
FIG. 6
1