Skil 3316 Instrucciones De Funcionamiento página 55

SM 2610017175 08-11:SM 2610017175 08-11.qxp 8/2/11 11:24 AM Page 55
Crown Molding Laying Flat on Table
Follow these instructions for cutting crown molding:
WARNING
conducting a simulated cutting cycle, and observe the
projected path of the saw blade. Keep hands at least six (6)
inches away from the projected path of the saw blade.
1. Set the bevel and miter angles using Chart 1 below.
Tighten the miter lock knob and the bevel lock handle
(Figure 33).
2. Position molding on saw table. Use the chart below for
correct position. Clamp workpiece in place using the
provided vise clamp. Use auxiliary work piece support or
auxiliary stand to support the crown molding. Firmly
support workpiece by hand that is located at least six (6)
inches away from the projected path of the saw blade.
WARNING
on, lower head assembly to make sure clamp clears guard
and head assembly.
3. Activate the switch. Lower the head assembly and make
your cut.
4. Wait until blade comes to a complete stop before
returning head assembly to the raised position and/or
removing workpiece.
Saw Operations
Be aware of the path of the saw blade.
Make a dry run with the saw OFF by
Use clamping position that does not
interfere with operation. Before switching
MAXIMUM
SIZE 4-1/2"
Chart 1: Crown Molding Flat on Table
5. ALWAYS TAKE A TEST CUT USING SCRAP TO
CONFIRM CORRECT ANGLES.
55
FIG. 33