Dust Collection - Bosch GEX34-6 Instrucciones De Funcionamiento Y Seguridad

Backing Pad Damper
Your tool is equipped with an integrated
backing pad damper ring. This damper
reduces the no-load speed, which helps
prevent swirl marks on the workpiece
surface and provides uniform finishing.
NOTE: If you notice steadily increasing no-
load speed, this indicates that the damper
ring is worn and needs to be replaced.
To replace damper ring, remove backing
pad as described in "Backing Pad
Installation" and remove worn damper ring
by pulling firmly out of locating groove.
Align notch on damper ring with locating
tab on shroud and depress ring with
thumbs until shroud seats into groove
completely around ring (Fig. 4).
Re-attach backing pad as described in
"Backing Pad Installation".
IMPORTANT: Ring should not have bends or
ripples when correctly seated.
Microfilter Dust Canister
The integral dust extraction system collects
sanding dust in canister supplied with your
sander. For maximum efficiency, the dust
canister should be emptied frequently
during operation.
empty it frequently after completion of
sanding and before storing the sander. Be
extremely careful of dust disposal, materials
in fine particle form may be explosive. Do
not throw sanding dust on an open fire.
Combustion from mixture of varnishes,
lacquers, polyurethane, oil or water with
dust particles can occur if there is a static
discharge, spark introduced in the box, or
excessive heat.

Dust Collection

Your tool is equipped
with a dust canister;
Assembly
FIG. 4
LOCATING
TAB
FIG. 5
DUST
CANISTER
-10-
BACKING
PAD
NOTCH
DAMPER
RING
SHROUD
1
2