Dust Collection - Bosch OS50VC Instrucciones De Funcionamiento Y Seguridad

BM 2609932873 11-12_BM 2609932873 11-12.qxp 11/27/12 10:48 AM Page 9
Notes:
• Make sure that SheetLoc™ System's front
clamp lever is latched, even when PSA
abrasive sheets are used.
• Remove PSA sheets soon after completing
each sanding operation in order to prevent
the adhesive from creating a hardened
bond with the backing pad.
REMOVING PSA ABRASIVE SHEETS
To remove, lift an edge of accessory with your
fingernail and peel it off the backing pad.
Note: If PSA paper is accidentally left on the
pad, the best way to remove it is to sand for a
few minutes to soften the adhesive backing.
PUNCH PLATE
After the paper has been installed, it will be
necessary to punch holes into the paper using
the punch plate provided with your sander.
Align sander base with punch plate and push
MICROFILTER DUST CANISTER
The integral dust extraction system collects
sanding dust in canister supplied with your
sander. For maximum efficiency, the dust
canister should be emptied frequently during
operation.
Your tool is equipped with
W RNING
a dust canister, empty it
frequently, after completion of sanding and
before storing the sander. Be extremely
careful of dust disposal, materials in fine
particle form may be explosive. Do not throw
sanding dust on an open fire. Combustion
FIG. 7

Dust Collection

2
DUST
C NISTER
down on sander until punch plate pierces the
paper. Then remove punch plate from sander
(Fig. 6).
FIG. 6
D
from mixture of varnishes, lacquers,
polyurethane, oil or water with dust particles
can occur if there is a static discharge, spark
introduced in the box, or excessive heat.
REMOVING AND INSTALLING
DUST CANISTER
To remove dust canister: Twist the dust
canister and simply pull away from the tool
(Fig. 7).
To install dust canister: align dust port with
hole in canister and push canister onto tool
until it locks into place (Fig. 8).
FIG. 8 I
1
C NISTER
-9-
PUNCH
PL TE
DUST PORT
DUST