CAME ZBX8 Manual Del Usuario página 9

Memorizing the code on the command board
c
- Connect the antenna with the RG58 cable to the apposite terminals on the board .
d
- The AF1 board must ALWAYS be inserted into the coupling when the power is off because the motherboard only recognises it hen it is
powered.
e
- Keep the "CH1" key pressed on the base card, the signal LED will fl ash.
e
- Press a transmitter key to send the code; the LED will remain lighted to signal memorization.
- Repeat the procedure of parts 1 and 2 with the "CH2" key, associating it wit another transmitter key.
N.B.: if the code needs to be changed, repeat the sequence described above.
Installation procedure for the remote control for automatically releasing the motor (pratico system)
f
- Disconnect the 230V power and insert the AF2 radio card (with the same frequency used for AF1 card) in the slot , the motherboard
recognises it only when it is battery powered.
g
- Insert the terminal (-, +) connected to the battery to the free coupling of the motherboard .
h
Note: the board must be battery-powered for saving procedures. Check the LED signalling 230V power is off.
j
i
- Keep the key on the basic board depressed. The signalling LED fl ashes (intermittent LED).
j
- Press a key (the same one memorized for opening the gate) on the transmitter to send the code. The LED will remain lighted to signal
successful memorization.
N.B.: if the code needs to be changed, repeat the sequence described above.
9
The data and information provided in this manual are to be considered susceptible to change at any time without warning, by CAME cancelli automatici s.p.a.