Master VARITEMP VT-750C Manual De Instrucciones página 6

Repair And Maintenance Instructions
All repairs and maintenance rec-
ommended in this instruction man-
ual must be performed by a
qualified repair technician who is
experienced with the repair of elec-
tric tools, a qualified service orga-
nization, or Master Appliance
Corp.'s Repair Department.
Please contact Master's Customer
Service Department for genuine
Master Appliance replacement
parts or for repair service.
Repair Service Dept
877-250-1934
sales@masterappliance.com
www.masterappliance.com
WARNING: Always unplug your
tool before performing any mainte-
nance or repairs. Use only identical
Master Appliance brand replace-
ment parts.
one year full Warranty
Master Heat Tools are carefully
tested and inspected before being
shipped from the factory.
We warrant our products to be free
from defects in materials and work-
manship, under normal use and
service, for one year from date of
purchase. In the event of a defect
in materials or workmanship we will
either repair or replace, at our
option, without charge any part
which in our judgement shows evi-
dence of such defect.
Warranty does not apply to wear-
able items such as attachments or
heating elements, which require
periodic replacement, nor does it
6
Motor Brushes
1) Unplug tool before removing
brushes.
2) Inspect brushes regularly (at
least every 100 hours of running
time). If brushes are less than
1/8" long, replace them immedi-
ately.
3) Remove brushes one at a time.
To remove, unscrew the brush
cap located on the side of the
housing and remove the brush-
spring.
4) Always replace brushes in sets
of 2 to ensure equal tension. If
returning partially used brushes,
match the curvature of the
brushes to the commutator.
5) To replace, insert new brush-
spring into hole and screw on
brush cap.
6) After second set of brushes are
worn down, replacement of the
armature may be necessary.
Return the tool to Master
Appliance Corp. Repair
Department or a qualified ser-
vice organization for service.
7) Always use original Master
Appliance Corp. replacement
parts.
apply if the heat tool has been mis-
used, abused, tampered with or
altered.
At the end of the warranty period,
Master Appliance shall be under
no further obligation, expressed or
implied. Master Appliance
assumes no responsibility for, and
this warranty shall not cover, any
incidental or consequential dam-
ages from any defect in products
or their use.
This warranty gives you specific
rights. You may also have other
rights which may vary from state to
state. Warranty information is
included within the Instruction
Lubrication
The bearings are lubricated at the
factory and require no further lubri-
cation.
Cleaning
Unplug heat gun before cleaning.
To clean outside of tool, use only a
mild soap and damp cloth. Do not
use other cleaning agents, turpen-
tine, gasoline, lacquer or paint thin-
ner, or other solvents that may
contain chemicals which are harm-
ful to plastics and other insulating
materials. Never immerse tool in a
liquid or allow a liquid to enter
inside the tool. Make sure all vents
and openings are free and clear of
debris.
Manual for each product or may be
obtained by contacting Master's
Customer Service Department.
Master Appliance Corp.
2420 18th Street
Racine, Wisconsin 53403
U.S.A.
Phone 262-633-7791
800-558-9413 (USA)
Fax 262-633-9745
sales@masterappliance.com
www.masterappliance.com
www.masterappliance.com