Assembly; Unpacking The Generator; Install Wheel Kit - Briggs & Stratton 030219 Manual Del Operario

ASSEMBLY

Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115. If calling for assistance, please have the
model, revision, and serial number from the data tag available.
See "Know Your Generator" for data tag location.

Unpacking the Generator

1. Set the carton on a rigid flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install these components:
• 13mm wrench
• Socket wrench with a 13mm socket
• Pliers
Figure 1 — Install Wheel Kit
Support Leg
ASSEMBLY
• Safety glasses
Refer to Figure 1 and install the wheel kit as follows:
1. Tip generator so that engine end is up.
2. Slide axle through both mounting brackets.
3. Place a wheel on each side as shown in Figure 1A.
4. Place a washer on axle and then place an e-ring in axle
groove.
E-rings can cause eye injury.
E-rings can spring back and become airborne
when installing or removing.
• Always wear eye protection when installing/removing e-rings.
5. Install e-ring with pliers, squeezing from top of e-ring
to bottom of axle.
6. Repeat step 4 and 5 to secure second wheel.
7. Tip generator so that engine side is down.
8. Line up holes in support leg with holes in generator
frame.
9. Attach support leg using two short (M8 x 16mm) cap
screws and two locking hex nuts.Tighten with a 13mm
socket and wrench.
10. Return generator to normal operating position (resting
on wheels and support leg).
Axle
Cap Screw
Wheel
Hex Nut
6
CAUTION
A
Axle
Wheel
Flat Washer
E-Ring